AS3643
Datasheet, Confidential - A p p l i c a t i o n I n f o r m a t i o n
At the pin GND a single via (or more vias, which are closely combined) connects to the common ground plane. This
via(s) will isolate the DCDC high frequency currents from the common ground (as most high frequency current will flow
between Loop1 and Loop2 and will not pass the ground plane) - see the ‘island’ in Figure 31 .
Figure 31. Layout recommendation
    
     
   
         
         
      
    
 
$     !         %
        &!     & "   & 
             %   
         
 '
 ) *   '
         
          
 ) *   (
        
         
AS3643
     (
        ! "
         # !           !   !
        
Note: If component placement rules allow, move all components close to the AS3643 to reduce the area and length
of Loop1 and Loop2.
An additional 100nF (e.g. Murata GRM155R61C104, >50nF @ 3V, 0402 size) capacitor C VIN2 in parallel to C VIN is rec-
ommended to filter high frequency noise for the power supply of AS3643. This capacitor should be as close as possi-
ble to the GND/VIN pins of AS3643.
5V Operating Mode
The AS3643 can be used to power a 5V system (e.g. audio amplifier). The operating mode is selected by setting regis-
ter bit const_v_mode (page 23) =1. In this operating mode, the current sinks are disabled and cannot be switched on
(no flash/torch operation is possible).
Note: There is always a diode between VIN and VOUT1/2 due to the internal circuit. Therefore VOUT1/2 cannot be
completely switched off
Figure 32. 5V Operating Mode
     
    
     
        
        
            
AS3643
www.austriamicrosystems.com/AS3643
 
1.5-4
          
  
      
30 - 33
相关PDF资料
AS3647-ZWLT IC LED DVR 1600MA FLASH 13WLCSP
AS3648-ZWLT-500 IC WHITE LED FLASH DVR 13WLCSP
AS3665-ZWLT IC LED DRIVER SMARTLIGHT 25WLCSP
AS3685B-T IC DVR PHOTOFLASH 1A 10-DFN
AS3685C-T IC DVR PHOTOFLASH 1A 10-DFN
AS3691B-ZMFT IC LED DVR 400MA RGB/WHT 64-MLF
AS3691B-ZTSP IC LED DVR 400MA RGB/WH 20ETSSOP
AS3693A-ZQFT IC LED DVR 16CH W/PWM 48-QFN
相关代理商/技术参数
AS3643-ZWLT-500 功能描述:IC WHITE LED FLASH DVR 13WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 特色产品:LM3445 TRIAC Dimmable LED Driver 标准包装:55 系列:PowerWise® 恒定电流:是 恒定电压:- 拓扑:PWM,降压(降压) 输出数:1 内部驱动器:无 类型 - 主要:- 类型 - 次要:高亮度 LED(HBLED) 频率:30kHz ~ 1MHz 电源电压:8 V ~ 12 V 输出电压:- 安装类型:表面贴装 封装/外壳:14-SOIC(0.154",3.90mm 宽) 供应商设备封装:14-SOICN 包装:管件 工作温度:-40°C ~ 125°C 产品目录页面:1285 (CN2011-ZH PDF) 其它名称:LM3445M
AS3644-ZWLT 功能描述:LED 驱动器 IC 1 输出 DC DC 稳压器 升压(升压) I2C 调光 320mA(闪存) 6-WLCSP(1.5x1.1) 制造商:ams 系列:- 包装:带卷(TR) 零件状态:有效 类型:DC DC 稳压器 拓扑:升压(升压) 内部开关:是 输出数:1 电压 - 供电(最低):2.5V 电压 -?供电(最高):5V 电压 - 输出:- 电流 - 输出/通道:320mA(闪存) 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C(TA) 安装类型:表面贴装 封装/外壳:6-UFBGA,WLCSP 供应商器件封装:6-WLCSP(1.5x1.1) 标准包装:12,000
AS3645A-ZWLT 制造商:ams 功能描述:IC PHOTOFLASH DRIVER 12WLCSP 制造商:ams 功能描述:T&R / WL-CSP12 (2.0x1.5x0.5)
AS3645-ZWLT 功能描述:IC PHOTOFLASH DRIVER 12WLCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 恒定电流:- 恒定电压:- 拓扑:升压(升压),切换式电容器(充电泵) 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:625kHz ~ 875kHz 电源电压:2.7 V ~ 5.3 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽) 供应商设备封装:10-µMAX 包装:带卷 (TR) 工作温度:-40°C ~ 85°C
AS3646-ZWLT 功能描述:IC LED DRIVER REGULATOR 12WLCSP 制造商:ams 系列:* 零件状态:有效 标准包装:500
AS3647B-ZWLT 功能描述:LED 驱动器 IC 2 输出 DC DC 稳压器 升压(升压) I2C 调光 800mA(闪存) 15-WLCSP 制造商:ams 系列:- 包装:带卷(TR) 零件状态:有效 类型:DC DC 稳压器 拓扑:升压(升压) 内部开关:是 输出数:2 电压 - 供电(最低):2.7V 电压 -?供电(最高):4.4V 电压 - 输出:2.8 V ~ 5.5 V 电流 - 输出/通道:800mA(闪存) 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C(TA) 安装类型:表面贴装 封装/外壳:15-UFBGA,WLCSP 供应商器件封装:15-WLCSP 标准包装:10,000
AS3647B-ZWLT-500 功能描述:LED 驱动器 IC 2 输出 DC DC 稳压器 升压(升压) I2C 调光 800mA(闪存) 15-WLCSP 制造商:ams 系列:- 包装:带卷(TR) 零件状态:有效 类型:DC DC 稳压器 拓扑:升压(升压) 内部开关:是 输出数:2 电压 - 供电(最低):2.7V 电压 -?供电(最高):4.4V 电压 - 输出:2.8 V ~ 5.5 V 电流 - 输出/通道:800mA(闪存) 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C(TA) 安装类型:表面贴装 封装/外壳:15-UFBGA,WLCSP 供应商器件封装:15-WLCSP 标准包装:500
AS3647-ZWLM 功能描述:LED 驱动器 IC 2 输出 DC DC 稳压器 升压(升压) I2C 调光 800mA(闪存) 13-WLCSP(2.25x1.5) 制造商:ams 系列:- 包装:带卷(TR) 零件状态:有效 类型:DC DC 稳压器 拓扑:升压(升压) 内部开关:是 输出数:2 电压 - 供电(最低):2.7V 电压 -?供电(最高):4.4V 电压 - 输出:2.8 V ~ 5.5 V 电流 - 输出/通道:800mA(闪存) 频率:4MHz 调光:I2C 应用:照相机闪光灯 工作温度:-30°C ~ 85°C(TA) 安装类型:表面贴装 封装/外壳:13-UFBGA,WLCSP 供应商器件封装:13-WLCSP(2.25x1.5) 标准包装:500